monoster - 8/29/19

engine:
    new valve guides (not needed for first fire)
    need to sort the oil in the cylinder issue.
        oil might be causing the higher compression.
        remove the head and replace the oil o-ring.
        get permatex copper gasket maker and seal the
        damn thing up. make sure to not fuck up 
        the timing. 
    need a lock washer on the engine sprocket. 
    may need a glob of jb weld on the oil seal for
        the clutch. don't want it to fall off. 

frame:
    need to grease the swing arm. 
    mount battery under seat. with terminals for
        battery tender.
    finish the tank. get off white and aqua blue
        and can of flat 2 part clear. 
    parts for powder coat: foot pegs, wheel hubs, 
        side stand.
    get wheels from excel. need to find out if 
        spokes will work with any wheels. 
        wheels will be 18 inch and black.
    check the parts book to see what the hell 
        the fiber washer on the wheels are. 
drive:
    wheel bearings for the rear. find first. 
    remove rear sprocket and send to rebelgears.com
    tires, find take offs or order new front.

work on:

Foil Decals for the tank.
https://www.eurojamb.com/collections/ducati-chassis/products/foil-moto-ducati-gas-tank-decal-set-0123-83-210-220-solid

Get the damn oil filter!
https://www.eurojamb.com/collections/ducati-engine/products/ducati-bevel-single-oil-strainer-filter-narrowcase-200-250-350

Valve guides - need.
https://www.eurojamb.com/collections/ducati-engine/products/ducati-single-valve-guide-set-200-250-350-450-1st-oversize

Kickstarter plate - only need the bolts.
https://www.eurojamb.com/collections/ducati-engine/products/ducati-kickstart-spring-update-kit-0603-07-000-narrowcase-250-350-bevel

Valve stem seals - need.
https://www.eurojamb.com/collections/ducati-engine/products/ducati-valve-guide-seal-set-bevel-200-250-350-450-750-860-900